Pair Of Motor Brushes For Older Powakaddy EMD Motor

Pair of Motor Brushes for older Powakaddy EMD Motor   This is a pair of motor brushes for the older Powakaddy EMD low profile motor. Please refer to the pic to make sure your brushes look the same as the more recent EMD motors used a similar brush. If your Powakaddy trolley has started to struggle going uphills then the chances are that you need to replace one or both of the motor brushes.   To test your current brushes: Remove the rubber boot from the end of the motor. Cut the plastic tie which is usually in place around the motor keeping the 2 wires intact. Remove both the upper and lower wire from the motor by pulling gently in the direction of the gearbox. Remove the plastic brush covers by sliding in the direction of the gearbox – this will release the brushes which will spring out to a certain extent. Remove both brushes and measure the length of them – they should be at least 1.5cm long.